GY-MAX4466 Electret microphone, amplifier

The GY-MAX4466 is a microphone amplifier module based on the MAX4466.

The module is characterized by particularly good sound and low noise and has a 20 - 20kHz microphone. With the built-in trim potentiometer a gain of 25x to 125x can be set. It is suitable for projects such as voice changers, audio recording / sampling or audio reactive projects.

Simple connection: GND for the ground connection, VCC for the input voltage and OUT for the audio signal (as a waveform). For the best result, the lowest possible supply voltage is recommended (e.g. 3.3 V for Arduino).

For audio-reactive projects, the use of an FFT driver library is recommended, which can record the audio input and "translate" it into frequencies. 

Note: 
The output pin of the module is not suitable for loudspeakers. An audio amplifier is required for a direct connection to a loudspeaker. No amplifier or decoupling capacitor is required for a connection to a microcontroller pin; the OUT pin can be connected directly to the ADC pin of the microcontroller. 

Technical data

• Input voltage: 2.4 - 5V
• Signal: Analog
• Microphone: 20-20kHz 
• Amplification: 25x to 125x
• Dimensions: approx. 20 x 14 x 8mm
• already soldered

 Scope of delivery:

• 1x GY-MAX4466 Electret microphone, amplifier