320A ESC for HSP HPI RC for car, boat etc.
Bidirectional electronic speed controller with brake (with waterproof function)
Parameters:
- Current parameters: Forward 320A, reverse 160A, brake 270A
- BEC output: voltage 5.6V, current 2A. (power supply for receiver and servos)
- Battery backup: 4-6 sets of nickel-hydrogen and nickel-cadmium (4.8V ~ 7.2V); Three sets of lithium batteries (7.4V-11.1V)
- Size: 43 mm (length) x 29 mm (W) x 27 mm (height) (Including heat sink section)
- Weight: 40 g
Special attention:
When using 3S (12 V), this electric controller can only operate motors with a maximum of 380. When using 2S (8.4 V), it can only operate motors with a maximum of 540
Instructions:
- Connect the power supply battery correctly, with the red wire at both ends of the terminal block indicating the positive terminal and the black wire indicating the negative terminal. (Or connect the standard DC battery connector, the Datian plug/T-plug/banana plug)
- Connect the red and black wires of the electrical control output to the red and black wires of the vehicle's 540 engine.
- Turn on the power switch of the power controller and the motor will "beep". Then turn on the transmitter and the motor will beep to indicate that the remote control signal has been successfully connected to the power controller.
Scope of delivery:
- 1x ESC 320A BEC / BDESC-S10E-RTR / motor driver
Further links to "ESC 320A BEC / BDESC-S10E-RTR / motor driver"
Accessories
