Radio relay - Motor control - Polarity reversal - Receiver and remote control - 12V, 433 MHz

Overview

• Powerful radio relay module with 433 MHz RF signal.
• The remote control has a high transmission power that can penetrate walls, floors, doors, etc.
• Simple handling
• The module is easy to configure and reset.
• The module is suitable for radio control of an electric motor (switch on / switch off / change direction), or alternatively for radio activation, deactivation and polarity reversal control of a DC voltage.
• There are 2 operating modes

Inputs:

• When the first button is pressed, the motor rotates in one direction. When released, the motor stops.
• When the second button is pressed, the motor rotates in the opposite direction. The motor stops when the button is released.
• Pressing the first button on the remote control once causes the motor to turn in one direction. Pressing the same button again deactivates the motor.
• Pressing the second button on the remote control once causes the motor to turn in the other direction. Pressing the same button again deactivates the motor.

Technical data:

• Receiver operating voltage: DC 12V
• Operating mode: momentary mode, toggle mode, toggle mode
• HF frequency: 433 MHz
• Reception sensitivity: approx. 105dbm
• Operating temperature: -10 ~ + 80
• Quiescent current: approx. 8mA
• Relay housing approx. 7.5cm x 5.5cm x 3cm

Scope of delivery:

• 1* radio relay - motor control - polarity reversal - receiver and remote control - 12V, 433 MHz

Instructions for use

Description of the three operating modes:
Operating modes: 1) Momentary; 2) Toggle; 3) Lock.

Momentary mode:
After successful pairing, press and hold the remote control button (e.g. A) in this mode to make the DC motor run forward. Release the button and the motor will stop. Press and hold the remote control button (e.g. B) to run the motor in reverse. Release the button and the motor is switched off.

Changeover mode:
In this mode, the DC motor starts forward after pressing the remote control button (e.g. A). Press the button again to switch the motor off. Press the remote control button (e.g. B) to run the motor backwards and again to switch it off again.

Locking mode:
After successful pairing, start the DC motor forwards by pressing the remote control button (e.g. A). Press the other button (e.g. B) to rotate the motor backwards. A third button (e.g. C) switches the motor off. (A remote control with at least three buttons is recommended)

To set the operating mode of the switch control:
Note: The mode can only be set when the LED on the receiver is off.

Setting the current mode:

Step 1: Press the receiver's learn button once. The LED lights up and indicates the setting mode.
Step 2: Press the desired button on the remote control (e.g. A). The LED flashes and goes out.
Step 3: Press another button (e.g. B) on the same remote control. The LED flashes and then lights up permanently. The momentary mode is successfully set.

Setting the switching mode:

Step 1: Press the receiver's learn button twice. The LED lights up to indicate the setting mode.
Step 2: Press the desired button on the remote control (e.g. A). The LED flashes and goes out.
Step 3: Press another button (e.g. B) on the same remote control. The LED flashes and then lights up permanently. The switching mode is successfully set.

Setting the locking mode:

Step 1: Press the receiver's learn button three times. The LED lights up and indicates the setting mode.
Step 2: Press a button on the remote control (e.g. A). The LED flashes and goes out.
Step 3: Press another button (e.g. B) on the same remote control. The LED flashes and then stays on. Locking mode is successfully set.