Kitronik pen lifter (pen holder) for :MOVE motor for BBC micro:bit

Get creative with the Pen Lifter add-on for the :MOVE motor for BBC micro:bit . This add-on allows you to make full use of the pin hole in the Kitronik :MOVE motor.

After installation, you can use the add-on to control when the pin is used with code. The assembly holds the pin firmly in place and the included servo can be used to raise and lower the pin. This allows the user to create complex patterns without unsightly movement marks.

The kit consists of a set of 3 laser-cut parts, a single 180-degree servo, a rubber band and the fasteners required to assemble it. The kit requires no soldering, but some simple mechanical assembly work. The kit comes with a booklet that guides the user through every aspect of assembly.

Notes:

• No pin is supplied with this kit, you can use your own pins.
• No soldering is required, but some simple mechanical assembly work is required.
• This kit is intended for use with the :MOVE motor for BBC micro:bit.

Features:

• Add a pen to the :MOVE motor for BBC micro:bit that can be raised or lowered by code.
• Draw complex shapes without unsightly "travel lines".
• This add-on comes with full assembly instructions.

Scope of delivery:

• 1 x 180 degree servo (3.3V compatible)
• 1 x M4 x 12 mm pan head screw
• 1 x M3 x 12 mm countersunk head screw
• 1 x M3 x steel hexagon nut
• 2 x M3 x 10 mm pan-head screw
• 1 x set of laser cut parts (3 pieces)
• 1 x rubber band