This extension is an input/output extension board for the Raspberry Pi PICO. The pins on the outside are each extended with a ping for voltage and GND. This is why it is also referred to as a sensor shield. In addition, all pins of the microcontroller are led out directly next to the controller as a header pin and can be tapped separately there.
The board is fully assembled and soldered.
The board has mounting holes for secure attachment to your project.
Notes:
- Please note that the power supply of the expansion board with the 7-12 V DC input supplies 5 V to the PICO, the VSYS pin and the 5 V rail in the lower right corner.
- The PICO's integrated voltage regulator then supplies 3.3 V to the 3.3 V rail (bottom right) and the other red pins.
- If no PICO is connected, there is no 3.3 V supply.
- If not already present, male pin headers must be soldered to your Pico so that it fits into the circuit board.
Overview:
- compatible with Raspberry Pi Pico
- 4 mounting holes 3mm each
- Voltage: 3.3V / 5V
- Weight: 35g
- Dimensions: approx. 76.8mm x 70x11.5mm
Scope of delivery:
- 1x Sensorshield GPIO for Raspberry Pi Pico
Further links to "GPIO sensor shield for Raspberry Pi Pico"
Zubehör
