LOKLiK Crafter cutting blade 60° - pack of 2

The LOKLiK cutting blade 60° - pack of 2 is specially designed for precision cutting of thicker materials up to 1.5 mm. With a cutting angle of 60°, these blades are perfect for projects that require extra accuracy, such as detailed patterns when cutting dense materials like thick cardboard and specialty paper. These blades are durable and remain sharp even with frequent use, ensuring consistent, clean cuts every time.

Please note:

• These blades are not compatible with the LOKLiK iCraft™ cutting machine.

You can cut the following with this blade:

• Craft foam
• Chipboard
• Glitter cardboard
• Aluminum foil
• Cardboard
• Passepartout
• Poster boards
• ...

How to install a new cutting blade in your LOKLiK Crafter:

1. Switch off the machine: Make sure that the cutting machine is completely switched off before you start changing the blade.
2. Remove the old blade: Carefully unscrew the blade holder and remove the old blade.
3. Insert new cutting blade: Remove a new 45° blade from the packaging and place it in the blade holder with the sharp side facing down.
4. Secure the blade holder: Screw the blade holder tight again to secure the new blade.
5. Test the blade: Turn the machine on and make a test cut on a scrap piece to ensure the blade is installed correctly and works as expected.

Care and maintenance

Store unused blades in a dry and safe place to prevent rust and damage. Regular cleaning of the cutting blade and holder can extend the life of the blade.