iCraft Deep Point Blade - Pack of 2

The iCraft deep-point blade pack contains 2 replacement blades. With a cutting angle of 60°, these blades can be used for heavy materials such as faux leather, PVC stencil magnet sheets, EVA foam sheets, etc . Whether you are cutting intricate details or working with different materials, these cutting blades provide the precision you need.

Please note:

• These blades are not compatible with the LOKLiK Crafter cutting machine.
• These iCraft deep point blades use a different blade holder than the fine point blades. See the deep point blade kit if you also need a holder.

You can cut with these blades:

• Artificial leather
• Shrink wrap
• PVC template
• EVA foam board
• Magnetic foils
• ..

to install a new cutting blade in your LOKLiK iCraft™:

1. Switch off the machine: Make sure that the cutting machine is completely switched off before you start changing the blade.
2. . Remove the old blade: Carefully unscrew the blade holder and remove the old blade.
3. Insert new cutting blade: Remove a new deep-point blade from the packaging and place it in the blade holder with the sharp side facing down.
4. Secure the blade holder: Screw the blade holder back on to secure the new blade.
5. Test the blade: Turn the machine on and perform a test cut on a scrap piece to ensure that the blade is properly installed and functions as expected.

Care and maintenance

Store unused blades in a dry and safe place to prevent rust and damage. Regular cleaning of the cutting blade and holder can extend the life of the blade.