Battery Shield V3 Raspberry Pi / Arduino / ESP32 - 2x 18650

Battery holder for 2x 18650 batteries / rechargeable batteries. 

It has overcharge and deep discharge protection, which significantly extends the service life of the 18650 batteries.

The integrated DIP switch allows users to switch between HOLD and NORMAL modes. In normal mode, it automatically switches off the voltage when the current is too low, while in HOLD mode it continues to deliver power and only switches off when the discharge protection is triggered.

Overview:

• this module is only suitable for 18650 batteries
• can power an Arduino or Raspberry Pi controller and sensors simultaneously
• has an output power of up to 2A
• 18650 batteries are not included in the scope of delivery

Specifications:

• with overcharge and undercharge protection
• with Micro-USB charging interface
• with USB-C charging interface
• Charging current: max. 0.5A
• with switch to control the USB output
• Output current at 5V: 2A, maximum 3A
• Output current at 3.3V: 1A
• Protection: with overcharge and deep discharge protection
• Input: micro and type C input
• Output: 1xUSB output, 5x 3.3V output, 5x 5V output
• LED indicator on the bottom: flashing means charging, stop flashing means fully charged
• Input voltage: 5~8V
• with 5x 3V/1A output
• with 5x 5V/2A output

Scope of delivery:

• 1* Battery Shield V3 Raspberry Pi / Arduino / ESP32 - 2x 18650